Smart sending?

copter · Post by **copter** » Mon Mar 06, 2006 3:19 pm

I have my i415 set to smart sending and it keeps updating from the same location. Any ideas? Thanks

Post by **ATSupport** » Mon Mar 06, 2006 4:25 pm

Is each data the same? If it varies enough, the program would treat them as distinct and send update.

copter · Post by **copter** » Mon Mar 06, 2006 5:42 pm

Thank you for the fast reply, the updated locations are changing I should have been able to figure that one out. Thanks again.

coasterjob · Post by **coasterjob** » Wed Mar 08, 2006 10:28 am

Is it possible for the readings to change enough when the handset is in a parked car? I am currently getting readings from a car that is parked, but it is varying by 200 yards or so. Is this normal?

I have a geofence set up for 1000 feet, yet i keep getting movement alerts..

Post by **ATSupport** » Wed Mar 08, 2006 11:21 am

GPS signal varies on hardware and surroundings. The average variation is about 100 feet but looks like it jumps a lot in your area.

coasterjob · Post by **coasterjob** » Wed Mar 08, 2006 11:33 am

ATSupport wrote:GPS signal varies on hardware and surroundings. The average variation is about 100 feet but looks like it jumps a lot in your area.

So this is normal, and acceptable? Just curious...
I prob need to widen my geofence??

Post by **ATSupport** » Wed Mar 08, 2006 12:01 pm

I think that's normal.

coasterjob · Post by **coasterjob** » Wed Mar 08, 2006 12:19 pm

Ok, cool...

Good to know