Mercury switch

Discussions about AccuTracking Starter Kit and phones.
Post Reply
ten5

Mercury switch

Post by ten5 » Sun Feb 26, 2006 1:03 pm

can I install a mercury switch to conserve batt power? if so how is this done? Thanks

ATSupport
AccuTracking Staff
Posts: 1856
Joined: Tue Jan 27, 2004 4:36 pm
Contact:

Post by ATSupport » Sun Feb 26, 2006 2:15 pm

I know some users have done this and it works great. Just make sure you set AccuTracking auto start with the phone.
AccuTracking Support
support(at)accutracking.com

Epoxy
New member
Posts: 8
Joined: Fri Aug 04, 2006 3:03 pm

phone auto-turn on?

Post by Epoxy » Fri Aug 04, 2006 4:00 pm

Does the i415 have a way to automatically turn itself on when connected to power?

I'd think the ideal instalation would be to have the phone connected to "accessory" power, which is only on when the car is on. The phone would continue to power itself using its battery after the car is turned off, but would eventually die after a few days. If the phone would automatically turn itself back on the next time the car was started, that'd rock.

lamanmi

Anyone found autopower up on connect

Post by lamanmi » Sun Feb 25, 2007 4:18 pm

Anyone find a way to have the i415 power on when power to cigarette lighter is turned on?

Slimson
Junior Member
Posts: 10
Joined: Tue Apr 11, 2006 9:20 pm
Location: WA

Post subject: Anyone found autopower up on connect

Post by Slimson » Thu Mar 01, 2007 3:05 am

I think most people just leave the phone powered up all the time and hooked to a source that is powered all the time.

The small amount of power used by the phone won't cause any significant drain on a car battery.

copter
Junior Member
Posts: 48
Joined: Thu Mar 02, 2006 3:28 pm

Post by copter » Wed May 02, 2007 10:16 pm

Batt and motion switch problem has been solved thanks to Rob
viewtopic.php?t=989

Post Reply